System information

8-8
Configuring for Network Management Applications
SNMP Communities
Monitoring and Managing
the Switch
CLI: Viewing and Configuring Community Names
Community Name Commands Used in This Section
Listing Current Community Names and Values
Listing Community Names. This command lists the data forcurrently con-
figured SNMP community names (along with trap receivers and the setting for
authentication traps — see “Trap Receivers and Authentication Traps” on
page 8-10).
Syntax: show snmp-server [<community-string>]
This example lists the data for all communities in a switch; that is, both the
default "public" community name and another community named "red-team"
Figure 8-3. Example of the SNMP Community Listing with Two Communities
To list the data for only one community, such as the "public" community, use
the above command with the community name included. For example:
show snmp-server [<community-string>] below
snmp-server page 8-9
[contact <contact-str>] page 8-9
[location <location-str>] page 8-9
[community <community-str>] page 8-9
[host <community-str> <ip-addr>]
[<none | debug | all | not-info | critical>]
page 8-12
[enable traps <authentication> page 8-12
Default
Community and
Settings
Non-Default
Community and
Settings
Trap Receiver
Data (See page
8-10.)