System information

8-11
Configuring for Network Management Applications
Trap Receivers and Authentication Traps
Monitoring and Managing
the Switch
CLI: Configuring and Displaying Trap Receivers
Trap Receiver Commands Used in This Section
Using the CLI To List Current SNMP Trap Receivers
This command lists the currently configured trap receivers and the setting for
authentication traps (along with the current SNMP community name data —
see “SNMP Communities” on page 8-6).
Syntax: show snmp-server
In the next example, the show snmp-server command shows that the switch
has been previously configured to send SNMP traps to management stations
belonging to the “public”, “red-team”, and “blue-team” communities.
Figure 8-4. Example of Show SNMP-Server Listing
show snmp-server below
snmp-server host
<ip-addr> <community-name>
[none | all | non-info| critical | debug]
page 8-12
snmp-server enable traps authentication page 8-12
Example of
Community
Name Data (See
page 8-6.)
Example of Trap
Receiver Data
Authentication
Trap Setting