Specifications

Getting Started with HP ProCurve Switching and Routing
Module 1 – 28 Rev. 9.41
Lab — Configure user passwords
You can perform the below mentioned steps to configure passwords for the manager
and operator users and save your configuration. For this simulation, a serial
connection has been established with the 5406zl switch, and you are at the
manager-level context.
1. Access the global configuration context.
Procurve Switch 5406zl# configure terminal
Note
On an actual switch, you can enter command shortcuts such as config.
2. Configure a manager password of
password1.
Procurve Switch 5406zl (config) # password manager
3. Configure an operator password of password1.
Procurve Switch 5406zl (config) # password operator
4. Save your changes.
Procurve Switch 5406zl (config) # write memory
5. Log into the switch again and enter the operator password.
6. Move to the manager-level context and enter the manager password to gain
access.
Procurve Switch 5406zl> enable
For HP Internal Use Only