Installation guide

NAC Policies
NAC Policy Tasks
6-10
10. Click on a cluster name.
11. Enter the names of Windows domains to be tested by this cluster for this
NAC policy, separated by a carriage return.
12. Enter a single endpoint or list of endpoints separated by a carriage return
using the endpoint IP address, MAC address, NetBIOS name, or host
name. Enter a range of IPs using a dash (-) between or by using CIDR
notation (see table 13-1, “CIDR Naming Conventions,” on page 13-9).
NOTE: You can leave the Domains and Endpoints areas blank if you do not want to
assign domains and endpoints to this policy.
TIP: Move the mouse cursor over the question mark (?) by the word Endpoints,
then click on the CIDR notation link to see the CIDR conversion table pop-
up window.