Installation guide

802.1X Quarantine Method
Setting Up the 802.1X Components
11-47
a. Select the Show icon in notification area when connected check box.
This enables the Windows XP balloon help utility, which can assist you
when entering information and troubleshooting errors.
5. Authentication tab –
a. Select the Enable IEE 802.1X authentication for this network check box.
b. Select an EAP type from the drop-down list. For this example, select
MD5-Challenge.
IMPORTANT: This EAP type must match the EAP type selected in
“Setting up the RADIUS Server”, step 7, step q on page 11-19.
c. Clear or select the Authenticate as computer when computer information
is available check box. The choice is yours.
6. Click OK.
7. Select to reboot if necessary.
Setting Up the Authenticator
This section provides sample configurations for the following switches:
■ “Cisco® 2950 IOS” on page 11-47
■ “Cisco® 4006 CatOS” on page 11-48
■ “Enterasys® Matrix 1H582-25” on page 11-49
■ “Extreme® Summit 48si” on page 11-49
■ “ExtremeWare” on page 11-50
■ “ExtremeXOS” on page 11-50
■ “Foundry® FastIron® Edge 2402” on page 11-51
■ “HP ProCurve® 420AP” on page 11-51
■ “HP ProCurve® 530AP” on page 11-52
■ “HP ProCurve® 3400/3500/5400” on page 11-53
■ “Nortel® 5510” on page 11-54
The lines that apply to 802.1X are shown in
green italic text. Make sure
that you add this information when configuring your switch.
Cisco® 2950 IOS
aaa new-model
aaa authentication dot1x default group radius
aaa authorization network default group radius