Installation guide

System Configuration
Enforcement Clusters
3-8
1. Click Add an Enforcement cluster in the Enforcement clusters & servers area.
The Add Enforcement cluster window appears. The General area is
displayed by default.
a. Enter a name for the Enforcement cluster in the Cluster name field.
b. Select one of the following access modes:
– normal – Either allows or quarantines endpoints depending on the
setup of the enforcement sever
– allow all – Allows all endpoints
– quarantine all – Quarantines all endpoints
NOTE: If you are setting up a cluster for the first time, and you have not yet added
an ES, select allow all until you have finished configuring NAC 800.
c. Select a NAC policy group from the NAC policy group drop-down list
(see “NAC Policies” on page 6-1).
2. Click Quarantining in the Add Enforcement cluster window. Complete the
steps described in “Quarantining” on page 3-49.
Figure 3-2. Add Enforcement Cluster Window