Owner`s manual
Diagnostic Devices, Inc.  www.prodigymeter.com
Prodigy Talking Meter   Owner’s Manual
26
27
Diagnostic Devices, Inc.  1.800.243.2636
Prodigy Talking Meter   Owner’s Manual
• Sites other Than Your Fingertip
  Please refer to the “About Alternative Site Testing (AST)” 
 Section.Pleaseconsultyourhealthcareprofessional
  before obtaining blood from sites other than your fingertip.
 Caution: The Prodigy AutoCode
®
 Meter only requires a tiny   
  blood sample to perform a test. Choose a different spot 
 eachtimeyoutest.Repeatedpuncturesinthesamespot 
  may cause soreness and calluses.
STEP 3: Gently Massage the Area
Do not smear the blood sample. 
To obtain the most accurate test 
results, wipe off the first drop of blood 
and gently squeeze another drop of blood. 
See Figures 29 and 30.
STEP 4: Remove the Lancet
Take the lancet out carefully. Place the 
protective cap back on the exposed 
tip of the lancet.
*Always use caution when removing the lancet. 
Discard the lancet according to your local regulations.
  Warning: The first drop of blood usually contains tissue 
  fluid and serum, which may affect the test result. It should 
  be discarded.
Alternative Site Testing (AST)
When you want to obtain blood from sites other than the 
ngertip,usetheclearcap.Screwtheclearcapontothe
Lancing Device until it is snug but not too tight, and then 
gotoStep6.
STEP 6: Cock the Lancing Device.
Slidetheejection/cockingcontrolback
until it clicks. If it does not click, the 
lancing device may have been cocked 
when the lancet was inserted. See 
Figure 27. 
*The Lancing Device is prepared and 
ready to lance your finger for a blood sample.
Getting a Blood Sample
STEP 1: Wash Your Hands and the Puncture Site 
Use warm, soapy water. 
Rinseanddrythoroughly.
STEP 2: Lance the Selected Puncture Site
• Fingertip
Holdthelancingdevicermlyagainstthe
sideofyournger.PresstheReleasebutton.
Youwillhearaclick,indicatingthatthe
puncture is complete. See Figure 28.
Figures 29 and 30
Figure 27
Figure 28










