Owner`s manual

PRODIGY AutoCode® Blood Glucose Meter PRODIGY AutoCode® Blood Glucose Meter
Owner’s Manual Owner’s Manual
36
Caution: Do not use test strips or control
solution that have exceeded the discard date,
are expired or have been damaged.
Your results may be inaccurate.
Contact Customer Care
If your test strips have been damaged or if you
continue to get out-of-range results, it means
that the system or the control solution may not
be working properly. DO NOT use the system to
test your blood glucose level. If you are unable to
resolve the problem, contact Customer Care at
1.800.243.2636.
37
Performing a Blood Glucose Test
Preparing the Lancing Device
STEP 1: Remove the cap of the
lancing device by twisting it off.
See Figure 22.
STEP 2: Insert a sterile lancet into the
lancet holder of the lancing
device and push down rmly until
the lancet is fully seated. Do not
twist the lancet. See Figure 23.
STEP 3: Remove the protective cap
from the lancet by twisting it and
then save it for later use.
See Figure 24.
STEP 4: Replace the cap onto the
lancing device. Screw the cap
until it is snug but not too tight.
STEP 5: Set the lancing level.
The adjustable tip offers ve (5)
levels of skin penetration. To
select the desired depth, twist the
Figure 22
Figure 23
Figure 24
Figure 25