Product Specs

Table Of Contents

Confidential

SPD RFID Reader 2021-09-23

SPD6873160007R07.docx Page 20 of 20

6.9. Conditions of Use

This section lists the requirements and conditions to consider during installation of the RFID

Reader.

1. The RFID Reader shall be used with an external fuse or current limiter with a maximum

rating of 10A.

6.10. FCC compliance statement

This device includes antenna elements that radiate electromagnetic energy. The device must not be

collocated or operating in conjunction with any other antenna or transmitter but does not require installation

instructions to provide a minimum separation distance.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case the user will be required to correct the interference at

his own expense.

Caution! Any changes / modifications not approved by the responsible party could void the user’s

authority to operate the equipment.

6.11. Industry of Canada statement

This device complies with Industry Canada licence-exempt RSS standard(s).

Operation is subject to the following two conditions:

1. this device may not cause interference, and

2. this device must accept any interference, including interference that may cause undesired

operation of the device.

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled

environment. This equipment does not require to be installed and operated with minimum distance

between the radiator & your body.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:

1. l'appareil ne doit pas produire de brouillage, etConfidential

2. l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d'en compromettre le fonctionnement.

Cet équipement est conforme aux limites d'exposition au rayonnement IC RSS-102 définies pour

un environnement non contrôlé. Cet équipement ne doit pas être installé et utilisé à une distance

minimale entre le radiateur et votre corps.