User manual

AX3210P 2. Specifications
AX3210P
• VeCAM Module for high power curvilinear
vertical arrays
• Acoustic Coverage Improvement Device
(A.C.I.D. Technology)
• Integrated suspension and transportation
systems
• Amp Ready format
Description
Model AX3210P is a 3-way, full-range bi-
amplifiable module for vertical arrays designed
for live concerts or for permanent installations.
It features two 10” woofers with ISV (Interleaved
Sandwich Voice) coil, SDR (Single Demodula-
tion Ring) and DDS (Double Silicon Spider).
Its 2-way, coaxial compression driver features a
neodymium magnet and a 2” throat. It mounts
a 4” annular membrane for the reproduction of
mid-range frequencies and a 2” membrane for
high frequencies. The average angular horizon-
tal coverage is 110
◦
(-6 dB), while the vertical
dispersion depends on the composition of the
array. Every single element, and particularly
the high-frequency wave guide, has been stud-
ied to combine at its best with the rest of the
system, especially when marked curvatures are
needed. The precise directivity control in the
high range reduces destructive interference to a
minimum. The wave guide, completely manu-
factured using a special toughened and damped
material, minimizes transfer losses while main-
taining the efficiency of the driver, especially at
band extremes. Model AX3210P is designed
(AMP READY Format) for the installation of on-
board amplifier/digital processor units currently
under development. The suspension and trans-
portation system is completely integrated with
the exception of its basic element, flying bar
KPTAX3210. This bar can suspend up to 24
AX3210P elements with a security factor of 7:1.
Data Sheet
System AX3210P
System Type 3-way full-range vertical
array element - bi-amp
Frequency Response 75 Hz - 20 kHz
Coverage Angle H. (-6 dB) 110
◦
average
Coverage Angle V. (-6 dB) depending on array size
Directivity Index (DI) depending on array size
Maximum Peak Output 131 dB@1m
Signal Processing Proel DSO26
Lake Contour Pro 26
Transducers
Mid Frequency Device 2 x 10” neodymium woofer
- 3” voice coil
Nominal Impedance 8 Ω
Power Rating 800 W AES
1600 W program
Sensitivity 99 dB SPL (2.83 V, 1 m)
High Frequency Device 2” coaxial compression
driver - horn loaded
Nominal Impedance 16 Ω
Power Rating 150 W AES
300 W program
Sensitivity 110 dB SPL (4 V, 1 m)
Mechanical Data
Construction trapezoidal (12
◦
)
15 mm birch plywood
internally reinforced
with paint finish
Flying System built in suspension system
Dimensions (WxHxD) 79.6 x 32.1 x 66.5 cm
Weight 51.5 kg - 113.5 lb
Weight With Skate 57.5 kg - 126.7 lb
Engineering specifications
The system should be a two-way passive enclo-
sure, with a frequency response from 75 Hz to
20 kHz and a horizontal coverage of 110
◦
. The
system should have a 4” driver with a coaxial di-
aphragm and a 2” throat fit with a wave guide,
power handling of 150 W AES and an impedance
of 16 Ohms. The system should also have two
10” low frequency loudspeakers with a 3” voice
coil. The system should provide a suspension
10