User manual
5. Guide to System Setup 5.2. STACKING AX3210P AND AX1118SP SYSTEMS
Figure 5.13: KPTAX3210 – positioned on the ground
Sequence of mounting operations
• Positioning flying bar KPTAX3210 on the ground
Mount feet 95AXMPDN on top of the flying bar (on the same side where the suspension shackle
is), then put the bar down on the ground in the position where you will stack the array and adjust
the feet so to lie the bar perfectly horizontal. Obviously, the ground needs to be absolutely stable
and compacted.
1. Adjusting feet height
At this point mark the position of the bar on the ground and lift it up vertically.
• Coupling the first speaker enclosure with KPTAX3210
The first loudspeaker of the array is coupled to the bar following the same procedure described for
the suspension of the array, that is the bar is coupled to the enclosure still mounted on its caster
board.
Couple the front cams of the flying bar to the front lateral bars on the enclosure and fasten them
with the pin.
Couple the back slotted bar to the flying bar inserting the pin in the hole of the slotted bar and in
the coupling frame of bar KPTAX3210. The coupling frame features four holes corresponding to
four different angles between the first enclosure and the flying bar, therefore you can select the
angle of the first enclosure among the following values: -2
◦
;-1
◦
;0
◦
and 1
◦
(see figure 5.14).
57