User manual

5.2. STACKING AX3210P AND AX1118SP SYSTEMS 5. Guide to System Setup




Figure 5.14: KPTAX3210 – adjusting the angle of the first enclosure

2. Coupling the bar with the first enclosure of the stacked array
• Positioning the first portion of the array on the ground
Once the first enclosure has been coupled to the flying bar, with a rotation you can lie this portion
of the array back on the ground in the position you had marked.
To avoid backward shifting of the array you have to use two 94AXMSPI pins and insert them in the
proper housings on the lateral crossbar of the flying bar (see figure 5.15).
• Coupling the next enclosures
You can stack another enclosure on the array lifting it up and placing it upside down on top of the
array. Now you can couple its front cams to the frame of the enclosure underneath and secure
them with the pins. Then lift the back part of the enclosure and set the relative angle using the hole
in the slotted bars on the back and the hole in the U-shaped frame of the enclosure underneath,
and secure their position with a pin (figure 5.16 shows the possible mounting angles).
58