User manual

5.4. STACKING AX2265P AND AX1115SP SYSTEMS 5. Guide to System Setup
Sequence of mounting operations
• Positioning flying bar KPTAX2265 on the ground
put the bar down on the ground in the position where you will stack the array and adjust the feet
so to lie the bar perfectly horizontal. Obviously, the ground needs to be absolutely stable and
compacted.
• Coupling the first speaker enclosure with KPTAX2265
The first loudspeaker of the array is coupled to the bar following the same procedure described for
the suspension of the array.
Couple the front cams of the flying bar to the front lateral bars on the enclosure and fasten them
with the pin. Couple the back slotted bar to the flying bar inserting the pin in the hole of the slotted
bar and in the coupling frame of bar KPTAX2265.
The angle between AX1115SP systems cannot be different from 0
◦
so you must use only the 0
◦
hole (see the side plate).
• Coupling the next AX1115SP enclosures
You can stack another enclosure on the array lifting it up and placing it upside down on top of the
array. Now you can couple its front cams to the frame of the enclosure underneath and secure
them with the pins. Then set the 0
◦
angle using the hole in the slotted bars on the back and the
hole in the frame of the enclosure underneath, and secure their position with a pin.
Verify that the angle has been set correctly on both slotted bars of the enclosure.
You can now proceed iteratively to complete the assembly of all the AX1115SP.
• Coupling the next AX2265P enclosures
You can stack another AX2265P enclosure on the array lifting it up and placing it upside down on
top of the array. Now you can couple its front cams to the frame of the enclosure underneath and
secure them with the pins. Then lift the back part of the enclosure and set the relative angle using
the hole in the slotted bars on the back and the hole in the frame of the enclosure underneath, and
secure their position with a pin.
Verify that the angle has been set correctly on both slotted bars of the enclosure.
You can now proceed iteratively to complete the assembly of the whole stacked array.
Sequence of disassembly operations
Disassembly works the same way assembly does, simply inverting the order of the operations.
Load limits
Flying bar KPTAX3210 can stack up to eight systems. The following chart shows all the possible combi-
nations:
AX2265P AX1115SP
8 0
6 1
4 2
2 3
0 4
74