User Manual
Table Of Contents
- INDEX-English
- TECHNICAL SPECIFICATIONS
- SETUP AND RACK MOUNTING (FIG. 1)
- LOUDSPEAKER CABLE
- CONNECTIONS
- FILTER RESPONSE (FIG.2)
- DIMENSIONS (FIG.3)
- FRONT PANEL (FIG.4)
- REAR PANEL (FIG.5)
- EXAMPLE A
- EXAMPLE B
- EXAMPLE C
- EXAMPLE D
- SAFETY AND PRECAUTIONS
- IN CASE OF FAULT
- TROUBLESHOOTING
- CE CONFORMITY
- PACKAGING, SHIPPING AND COMPLAINT
- WARRANTY AND PRODUCTS RETURN
- INSTALLATION AND DISCLAIMER
- POWER SUPPLY AND MAINTENANCE
- GENERAL INFORMATION
- INSTRUCTIONS
- INDICE-Italiano
- SPECIFICHE TECNICHE
- INSTALLAZIONE A RACK (FIG. 1)
- CAVO ALTOPARLANTE
- CONNESSIONI
- RISPOSTA FILTRI (FIG.2)
- DIMENSIONI (FIG.3)
- PANNELLO FRONTALE (FIG.4)
- PANNELLO POSTERIORE (FIG.5)
- ESEMPIO A
- ESEMPIO B
- ESEMPIO C
- ESEMPIO D
- AVVERTENZE PER LA SICUREZZA
- IN CASO DI GUASTO
- PROBLEMATICHE COMUNI
- CONFORMITÀ CE
- IMBALLAGGIO, TRASPORTO E RECLAMI
- GARANZIE E RESI
- INSTALLAZIONE E LIMITAZIONI D’USO
- ALIMENTAZIONE E MANUTENZIONE
- INFORMAZIONI GENERALI
- ISTRUZIONI
14
1 input only, but the speakon cable must be custom wired as follows: at the amplier side it must be wired 1+ for
posive terminal and 2- for the negave terminal, at the speaker side the cable must be wired as usual 1+ for posive
terminal and 1- for the negave terminal.
Always connect a loudspeaker with a minimum impedance of 8 ohm or more.
NOTE: Use only loudspeaker cables, never signal cables, i.e. those normally used for microphones, instruments and audio
equipment in general.
14. Channel 2 SPEAKON output
Accepts a female Neutrik Speakon NL4FX connector wired in this way:
• PIN 1+ connected to POSITIVE output of Channel 2;
• PIN 1- connected to NEGATIVE output of Channel 2;
• PIN 2+ and 2- NOT connected.
This is the amplied output of the signal applied to channel 2 input if the amplier is set in STEREO mode or the signal
applied to channel 1 input if the amplier is set in PARALLEL mode.
Always connect a loudspeaker with a minimum impedance of 4 ohm or more.
15. Fan
Fan Air cooling vent: always keep it clear of cables or other objects.
16. AC~ SOCKET
Here’s where you plug in your mains supply cord. You should always use the mains cord supplied with the device. Be
sure that your device is turned o before you plug the mains supply cord into an electrical outlet.