User Manual

4. INSTALLATION

1. Input connections

• MICROPHONE/ MICROPHONE STANDS CONNECTIONS:

use only shielded cable with any kind of microphone used.

Revert to (fig.2 ref.4)

Set input level to MICRO level , PIN1 position ON

Nota: if the microphone stand is active, select LINE level PIN1 position OFF

Advice: For use for speech, set PIN3 on position ON.

For microphone with Phantom power set PIN4 on position ON.

• LINE INPUT CONNECTIONS(CD, AM/FM TUNER, etc..)

I use shielded cable for long distance)

Revert to (fig.2 ref.4), set input level to LINE level, PIN1 on position OFF ( Phantom power supply disabled ).

Advice: for use for speech purposes set PIN3 on position ON.

For different connections purposes, apply to the following schemes::

Unbalanced connection : ( unbalanced signal- XLR plug )( soldering view side)

Balanced connection:balanced signal –XLR plug soldering view side)

Unbalanced connection with mono jack ( main wire- shielded cable part)

Unbalanced connection on EUROBLOC terminal

Unbalanced connection on EUROBLOC connection