Specifications

10
RM300
Bodypack WHX31 (fig.3)
1. Bat.Lo
Turning on the transmitter, this LED lights up for a while to indicate that the battery is charged and the transmitter is working
properly. When the battery charge level is too low, thus not allowing a proper signal transmission, this LED is constantly lighted,
in this condition we suggest you immediately replace the battery.
2. Power Selector
This 3 position selector allows to turn on/off the transmitter, as well as to activate/deactivate the audio source connected to MIC
input. Batt.lo LED should turn on for a while.
3. Volume Control
This control allows the user to adjust transmitter volume, and to adapt it to input signal of different sensitivity.
4. Mic In Input
5. This 3,5 mm jack allows the connection an audio source to be transmitted.
6. Sens Selector
This selector allows the user to select three sensitivity levels:
a. position 1 = Line ( guitar / bass)
b. position 2 = HEADSET (dynamic)
c. position 3 = LAVALIER (condenser)
7. Battery Older
Unscrewing the cover, you can access the alkaline 9 V battery receptacle, useful for transmitter operation.
WARNING
LICENSING INFORMATION
Changes or modifications not expressly approved by Proel S.p.A. could void your authority to operate the equipment.
Licensing of wireless microphone equipment is the user’s responsibility, and licensability depends on the user’s classification and
application, and on the selected frequency. Proel strongly urges the user to contact the appropriate telecommunications authority
concerning proper licensing, and before choosing and ordering frequencies.
IMPORTANT!
This equipment may be capable of operating on some frequencies not authorized in your region. Please contact your national
authority to obtain information on authorized frequencies for wireless microphone products in your region.
Consult local or national radio spectrum authorities for information on possible restrictions or necessary authorizations before
using this Short Range Device.
The product is in compliance with Directive 89/336/EEC (Electromagnetic Compatibility) and following modifications 92/31/EEC
and 93/68/EEC It is also in compliance with Directive 73/23/EEC (Low Voltage) and following modifications 93/68/EEC.
PROEL S.p.A hereby, declares that this wireless microphone system complies with the essential requirements and other relevant
provisions of Directive 1999/5/EC.
PROEL S.p.A. Via alla Ruenia 37/43 64027 Sant’Omero (Te) – Italy Tel: [phone] Fax: [phone] [e-mail]
PROEL S.p.A. pursues a policy of continuous research and development.
PROEL S.p.A. reserves the right to modify product circuitry and appearance at any moment, without prior notice.