User Manual

9
WEARING THE BODYPACK RMW1H
As show in FIG.10 it’s possible to wear the bodypack to a belt, strap or dress vertically or horizontally and
simply turning the spring on the other side, in any case be careful don’t fold or pull the antenna.
SET AUTOMATICALLY A SINGLE SYSTEM
Be sure that the transmitter is switched OFF.
Press on LCD appears then press , if you don’t press the
button into 5 seconds the receiver goes back to normal operation.
The receiver searches a free channel in the selected group
(note: it searches for a free frequency avoiding previously set channels or TV channels)
and when it is found a fixed channel is set
TURN ON the transmitter and expose its IR to IR of the receiver as show in FIG.11
Press ASC : now the transmitter is programmed to the same channel. In order to be sure check
that you have to see the same channel number on it and that the READY LED on the receiver is ON.
SET MANUALLY A CHANNEL GROUP
Press X 2: on LCD appears , then press to choose the channel
group from 1 to 14.
If you don’t press any button after 5 seconds the transmitter goes back to normal operation.
SET MANUALLY A CHANNEL NUMBER
Press X 3: on LCD appears then press to choose the channel
from 1 to 11.
If you don’t press a button for 5 seconds the transmitter goes back to normal operation.
SET AUTOMATICALLY THE SECOND RECEIVER
After you have set the first receiver and transmitter, leaving ON the first transmitter repeat the operation for
the second receiver and transmitter: the second receiver automatically detects the first transmitter channel,
discards its channel and selects another free channel to set the second transmitter.
SET AUTOMATICALLY THE THIRD AND SUBSEQUENTLY RECEIVERS
Set another group every two receiver-transmitter and, leaving ON the previous transmitters, set the other
receiver-transmitter channels: this method DO NOT AVOID completely THE INTERMODULATION problem but
it reduces its probability.