User manual

11
6. PRESET MONITOR/FOH selector
This switch allows the selec on between two equalisa on se ngs, suited to two diff erent uses.
MONITOR
Suited for stage monitoring sound reinforcement for an improved feedback rejec on.
FOH
This preset has been designed for typical sound reinforcement applica ons with the speaker mounted on fl oor
stand.
7. POWER switch
Speaker is "ON" when the switch is in the "I" posi on.
NOTE: When you shut down your equipment, turn off the speaker fi rst. When powering up, turn on the speaker last.
8. ON indicator
GREEN LED: when lighted indicates that the amplifi er has been turned on and AC power is available.
9. LINE VOLTAGE selector
This switch sets the AC voltage line of your country (usually it is set by factory and isn't necessary to change it). The 115V
se ng is for mains line in the range of 105-120V~ and 230V se ng is for mains line in the range of 210-240V~.
WARNING: an incorrect se ng of AC LINE VOLTAGE could damage seriously the internal electronics!
10. AC~ socket
Here’s where you plug in your speaker’s mains supply cord. You should always use the mains cord supplied with the
speaker. Be sure your speaker is turned off before you plug in the cord.
11. FUSE holder
Here is where the mains protec on fuse is placed.
REPLACE THE PROTECTION FUSE ONLY WITH SAME TYPE AS SHOWN ON THE PRODUCT.
IF AFTER THE SUBSTITUTION, THE FUSE INTERRUPTS AGAIN THE APPARATUS WORKING, DO NOT TRY AGAIN
THEN CONTACT THE PROEL SERVICE CENTER.