User Manual

loudspeakers in the array column.
KPTSW215 y bar maximum capacity is 540 Kg (1190 lbs) with the
0° angle. It can support, with a safety factor of 10:1, up to:
• 8 AX2065A + 8 AX2065P (ybar from 0° to 10°)
• 12 AX2065A (ybar from 0 to 10°)
• 2 SW215AF + 4 AX2065A + 4 AX2065P (ybar at 0°)
• 2 SW215AF + 8 AX2065A (ybar at 0°)
• 6 SW215AF (ybar from 0° to 5°)
Follow the sequence in the gure for xing the y bar at the rst box.
Usually this is the rst step before liing up the system. Be careful to
insert properly all the locking pins (1)(2) and (3)(4) then the shackle
(5) in the right holes as specied by the aiming soware.
When liing the system always proceed gradually step by step,
paying aenon to secure the y bar to the box (and the box to the
other boxes) before pulling up the system: this makes easier to insert
properly the locking pins. Also when the system is released down,
unlock gradually the pins.
During the liing be very careful to not let the cables enter the space
between one enclosure and the other, as their compression could
cut them.
Please note that the Rear Link Bar of the SW215 cabinet has two
holes (see gure): the hole signed as nr.1 must be used for SW215-
SW215 sub-sub link, hole signed as nr.2 must be used for SW215-
AX2065 sub-sat link.
SUSPEND HOLES
SUSPEND HOLE
INDICATOR
REAR BOX
PIN ATTACHMENT
FRONT BOX
PIN ATTACHMENT
FRONT BOX
PIN ATTACHMENT
STRAIGHT SHACKLE 16mm
M10 FOOT FOR
STACKED INSTALLATION
(OPTIONAL)
IDENTIFICATION AND
DATA LABEL
KPTSW215 FLY BAR AND ACCESSORIES
1
2
3
4
1
2
5
KPTSW215 FLY BAR ASSEMBLY SEQUENCE
1 = SW215-SW215 hole
2 = SW215-AX2065 hole
none = rest hole
SW215 REAR LINK BAR