Instruction Manual

15
15. Installation
15.1 Installation Requirements
15.2 Attachment / Removal
 Attachment
Although the figure shows the procedure to
attach the unit to the LT-3200 Series, the
same procedure is used to attach the unit to
the LT-3300 Series.
(1) Attach the first CANopen Master Unit
to the rear side of the LT.
Peel off the seal for EXT2 on the rear
side of the LT in advance. Pull out the
latch button upward as shown in the
figure. Insert the extension connector
on the left side of the CANopen Mas-
ter Unit into the AUX unit interface/
expansion unit (EXT2) of the LT.
(2) Push down the latch buttons on the top
to secure the CANopen Master Unit to
the LT.
• Make sure to fix the CANopen Master
Unit to the LT securely using the latch
buttons.
100
[3.94]
Unit: mm [in.]
100
[3.94]
100
[3.94]
100
[3.94]
LT with CANopen
Master Unit
100
[3.94]
100
[3.94]
100
[3.94]
(2) Pull out the
latch button.
(1) Peel off the
seal in advance.
(3) Insert the
connector into
the AUX unit
interface/expan-
sion unit (EXT2).
Push down
the latch
button.