User guide

GP3000 Series Hardware Manual

5-2

This section describes the DIO Connector packaged with the DIO board type unit of the GP3000 series.

This connector is an accessory of the GP unit. It is also offered as an optional maintenance item by Pro-face.

5.1 DIO Interface (Connector)

This interface is used to connect an external I/O device.

SEE

2.2 Optional Item for the DIO Board Type (page 2-7)

• When you use the DIO board type unit of the GP3000 series, read this section in conjunction

with the specifications of your GP series (Chapter 4).

• This section describes the information specific to the DIO board type unit of the GP3000 series.

The information common to the standard type and DIO board type units of the GP3000 series is

described using the model of the standard type.

(Example) For information about model AGP3500-T1-D24-D81K, read the information about

the standard type model “AGP-3500T”.

• When preparing the cable to connect the wiring, check the pin numbers inscribed

on the DIO Connector.

Recommended connector 1-1871940-6 <Tyco Electronics AMP.>

Pin Arrangement Pin No. Signal Name Pin No. Signal Name

A1 0V B1 +24V

A2 OUT1 B2 OUT0

A3 NC B3 COM

A4 IN5 B4 IN4

A5 IN3 B5 IN2

A6 IN1 B6 IN0

(Cable connection side)