User guide

Chapter 5 DIO Connector

5-5

Output Specifications (Source type)

 Output Circuit (Source type)

Rated Voltage DC 24V

Rated Voltage Range DC 20.4V to DC 28.8V

Output Method Source Output

Maximum Load Voltage 0.2A /point, 0.4A /common

Output Voltage Drop DC 1.5V or less

Output Delay Time

OFF to ON: 1ms or less

ON to OFF: 1 ms or less

Voltage Leakage (when OFF) 0.1mA or less

Clamp Voltage 39V ±1V

Type of Output Transistor Output

Common Lines 1

Common Design 2 points/1 common line

External Connection 12-pin connector (also used for Input)

Output Protection Type Output is unprotected

Internal Fuse 1.5A, 125V DIP fuse (not replaceable)

Surge Control Circuit Zener diode

Output Points 2

Output Signal Display No LED indicators

Status Display Element None

Isolation Method Photocoupler Isolation

External Power Supply DC 24V

• Since the output terminals are not electrically protected, an output line might be short-circuited

or a connection fault might damage the GP unit. Please install an applicable fuse to prevent an

overload in the circuit, if necessary.

Internal Circuit

+24V B1

OUT0 B2

OUT1 A2

0V A1

Fuse 1.5A

DC 24V

External Power