User guide

GP3000 Series Hardware Manual
6-2
This section describes the FLEX NETWORK Connector packaged with the FLEX NETWORK board type
unit of the GP3000 series.
This connector is an accessory of the GP unit. It is also offered as an optional maintenance item by Pro-face.
6.1 FLEX NETWORK Specifications
Connect the FLEX NETWORK Connector (accessory) to the GP unit and then connect I/O units or other
FLEX NETWORK units.
6.1.1 FLEX NETWORK Interface (Connector)
SEE
2.3 Optional Items for the FLEX NETWORK Board Type (page 2-7)
• When you use the FLEX NETWORK board type unit of the GP3000 series, read this section in
conjunction with the specifications of your GP series (Chapter 4).
• This section describes the information specific to the FLEX NETWORK board type unit of the
GP3000 series.
The information common to the standard type and FLEX NETWORK board type units of the
GP3000 series is described using the model of the standard type.
(Example) For information about model AGP3500-T1-D24-FN1M, read the information about
the standard type model “AGP-3500T”.
Applicable connector 284510-6 <Tyco Electronics AMP.>
Pin Arrangement Signal Name Description
1TR+ CH1 communication data
2TR− CH1 communication data
3 SLD CH1 cable, shielded wire
4TR+ CH2 communication data
5TR− CH2 communication data
6 SLD CH2 cable, shielded wire
6 5 4 3 2 1
(Cable connection side)