Owner's manual

Pin Assignments and Signal Names for Serial Interface

The CD, DTR, and DSR are connected together inside of the FP.

Connector.................. Dsub 9 pin female

Connector set screw.. Inch type (4-40)

Cable......................... SIO cable for FP manufactured by Pro-face.

FP61V-IS00-O

Concerning Signal Names

Signal names used for the serial interface on FP units are designed to match the pin order

used on most PC serial interfaces, so that a straight cable can be used to connect the two.

Therefore, connect each pin’s signal to the same signal name on the PC side.

For example, pin #2 ‘RD’ should be connected to the ‘RD’ input terminal on the PC’s

connector.

Refer to the FP-3500T/3600T/3650T series User Manual’s section “Cable Diagrams” for

each signal’s direction.

 USB Interface (Type-B connector : Up-Stream Port)

Pin Assignments and Signal Names for USB Interface

Cable......................... USB cable manufactured by Pro-face.

FP-US00

Pin No. Signal Name Condition Pin Location

1 CD Carrier Detect

2 RD Receive Data (FP->Host)

3 SD Send Data (FP<-Host)

4 DTR Data Terminal Ready

5 GND Ground

6 DSR Data Set Ready

7 RS Request to Send (FP<-Host)

8 CS Clear to Send (FP->Host)

9 NC (Used internally)

Pin No. Signal Name Condition Pin Location

1 USB1-5V +5VIN

2 USBD1(-) USB data(-)

3 USBD1(+) USB data(+)

4 GND Ground

• If a cable other than the specified USB cable is used, product

performance cannot be guaranteed due to the possibility of noise

interfering with the FP unit’s operation.