User guide

Chapter 6 Setting up and Adjusting the FP unit

6-3

The factory default for the FP unit’s Dip Switches and Slide Switch are as follows.

SW1

•SW1-2

Dip Switch SW1-2 is used to display or hide the OSD.

To hide the OSD, set the switch to ON. To display the OSD, set the switch to OFF.

The default setting is OFF. (OSD is displayed.)

SW2

• Slide Switch is used to switch the data input/output (command control) method on the touch panel

between USB and RS-232C.

The default setting is RS-232C.

SW1-1 Reserved (Always OFF)

SW1-2 Display/Hide the OSD

SW1-3 Reserved (Always OFF)

SW1-4 Reserved (Always OFF)

SW1-5 Reserved (Always OFF)

SW1-6 Reserved (Always OFF)

SW1-7 Reserved (Always OFF)

SW1-8 Reserved (Always OFF)

1 2 3 4 5 6 7 8

232

USB