User guide

FP3000 Series User Manual
4-20
4.2.3 Interface Specifications
Analog RGB Interface
 Display Area
The number of dots (pixels) displayed are as follows.
Input signal type Analog RGB
Input signal
characteristic
Image signal: analog RGB
Synchronous signal: TTL level, negative polarity or positive polarity
Scanning type: non-interlaced
Setting via OSD
(On Screen Display)
• CONTRAST
• H-POSITION
• H-size
• DIMMER (BACKLIGHT)
• ALL RESET (DEFAULT)
• BRIGHTNESS
• V-POSITION
• PHASE
• SHARPNESS
Size
H.Sync.
(kHz)
V.Sync.
(Hz)
Dot Clock
(MHz)
Screen
Resolution
Expansion
(H:Horizontal)
(V:Vertical)
Display
Resolution
640 × 350
*1
*1 When the 350 pixel (vertical) signal setting is selected, 400 pixels, including 50 pixels at the
top and at the bottom of the screen will be enlarged and displayed at 600 pixels (1.5times).
31.469 70.000 25.175
× 1.25(H)
× 1.5(V)
800 × 525
640 × 400 31.469 70.000 25.175 800 × 600
640 × 400 24.827 56.420 21.053 800 × 600
640 × 480 31.469 59.992 25.175
× 1.25(H)
× 1.25(V)
800 × 600640 × 480 35.000 66.670 30.240
640 × 480 37.861 72.810 31.500
720 × 350
*1,*2
31.469 70.000 28.320
× 1.1(H)
× 1.5(V)
800 × 525
720 × 400
*2
*2 When you use this resolution, set “ON” for “720 × 400 Mode” in the OSD (On Screen Display)
System Settings.
31.469 70.000 28.320 800 × 600
800 × 600 35.156 56.250 36.000
× 1.0 800 × 600
800 × 600 37.879 60.317 40.000