User guide

Connecting the FP to a PC

The FP3000 Series is designed for the following resolutions.

Be aware that some types of devices for image signal output may not be within the ranges specified in this document, and,

therefore, cannot be connected to the FP.

Also, if you change your PC’s Analog RGB/DVI-D board, there is the possibility that the new board may not be able to be

connected to the FP.

Series Full Resolution

FP-3500T Series 640

×480

FP-3600T Series 800

×600

FP-3650T Series 1024

×768

FP-3710T Series 1024

×768

FP-3900T Series 1280

×1024

SEE

FP-3500T Series

4.1.3 Interface Specifications (page4-6)

FP-3600T Series

4.2.3 Interface Specifications (page4-20)

FP-3650T Series

4.3.3 Interface Specifications (page4-33)

FP-3710T Series

4.4.3 Interface Specifications (page4-47)

FP-3900T Series

4.5.3 Interface Specifications (page4-60)

• When a signal timing value not compatible with this device is entered, or if the

entered timing is larger than can be displayed by the dot clock, an “Out of range”

message is displayed. If this occurs, be sure to read your computer’s manual

and enter a value that is compatible with this device.

• If no signal (synchronized signal) is entered, a “No signal” message is displayed.