User guide

FP3000 Series User Manual
4-60
4.5.3 Interface Specifications
Analog RGB Interface
 Display Area
The number of dots (pixels) displayed are as follows.
Input signal type Analog RGB
Input signal
characteristic
Image signal: analog RGB
Synchronous signal: TTL level, negative polarity or positive polarity
Scanning type: non-interlaced
Setting via OSD
(On Screen Display)
• CONTRAST
• H-POSITION
• H-size
• DIMMER (BACKLIGHT)
• ALL RESET (DEFAULT)
• BRIGHTNESS
• V-POSITION
• PHASE
• SHARPNESS
Size
H.Sync.
(kHz)
V.Sync.
(Hz)
Dot Clock
(MHz)
Screen
Resolution
Expansion
(H: Horizontal)
(V: Vertical)
Display
Resolution
640 × 400 31.469 70.000 25.175
× 2(H)
× 2.56(V)
1280 × 1024
640 × 480 31.469 59.992 25.175
× 2(H)
×2.13(V)
1280 × 1024
640 × 480 35.000 66.670 30.240
640 × 480 37.861 72.810 31.500
640 × 480 37.500 75.000 31.500
720 × 400
*1
*1 When you use this resolution, set “ON” for “720 × 400 Mode” in the OSD (On Screen Display)
system settings.
31.469 70.000 28.320
× 1.77(H)
× 2.56(V)
1280 × 1024
800 × 600 35.156 56.250 36.000
× 1.6(H)
× 1.7(V)
1280 × 1024800 × 600 37.879 60.317 40.000
800 × 600 46.875 75.000 49.500
1024 × 768 48.363 60.004 65.000
× 1.25(H)
× 1.33(V)
1280 × 10241024 × 768 56.476 70.069 75.000
1024 × 768 60.023 75.029 78.750
1280 × 1024 63.981 60.000 108.000
× 1.0 1280 × 1024
1280 × 1024 79.976 75.000 134.999