Owner's manual

2
• During backlight replacement, be sure to protect the front
surface of the FP’s display so that it is not scratched or
damaged.
• The FP has both an upper and a lower backlight bulb. Be sure
to replace both at the same time.
• Since CFL is used for the backlights, they should be disposed
of in a manner appropriate to your local government’s laws or
regulations.
3) Remove the three (3) inner unit
attachment screws.
1) Place the FP on a flat worktable
with the front panel facing
down.
2) Loosen the nine (9) rear cover
attachment screws, and remove
the rear cover.


 Backlight Replacement
Use the following steps to change the backlight.


 Removing the Backlights
Replace the backlight according to the following procedure. (The following
explanation assumes that the FP has already been removed from its operation
panel)
Inner unit
Since the attachment screws are small, be sure not to lose
them or allow them to fall inside the FP’s case.
Inner unit
attachment
screws
Rear Cover