Owner's manual

4
.FP790T-BL00-MT01-CP 2001 Digital Electronics Corporation


Attaching the Replacement Backlights
• Be sure not to pinch or cut any of the FP unit's internal
wiring when closing the rear cover.
• If any of the attachment screws becomes misplaced, check
to be sure that they have not fallen inside the FP. If a screw
has fallen inside the FP, do not connect the FP unit’s power
cord until the screw has been removed.
After changing the backlight, be sure to check that your FP display operates cor-
rectly. If a problem occurs, contact your local FP distributor.
3) Connect all four (4) backlight power connectors.
4) Replace all three (3) inner unit attachment screws to secure the
inner unit in place.
5) Reattach the rear cover, and replace the nine (9) rear cover
attachment screws.
2) Secure each backlight cable in
place by inserting it into its
Cable Clamp.
Cable Clamps
• Each backlight package contains an upper and a lower
backlight. Be sure to insert each backlight into the correct
holder.
• When inserting the backlight into its holder, be careful
not to cut or pinch your fingers on the Positioning Tab’s
edges.
1) Insert each replacement backlight
completely into its holder, until
the Positioning Tab’s hole is over
the Positioning Pin.
Positioning Pin
Positioning Tab