Manual

Chapter 4 Specifications
4-5
4.1.3 Interface Specifications
Analog RGB Interface
 Display Area
The number of dots (pixels) displayed are as follows.
Input signal type Analog RGB
Input signal
characteristic
Image signal: analog RGB
Synchronous signal: TTL level, negative polarity or positive polarity
Scanning type: non-interlaced
Setting via OSD
(On Screen Display)
• CONTRAST
• H-POSITION
• H-size
• DIMMER (BACKLIGHT)
• ALL RESET (DEFAULT)
• BRIGHTNESS
• V-POSITION
• PHASE
• SHARPNESS
Size
H.Sync.
(kHz)
V.Sync.
(Hz)
Dot Clock
(MHz)
Screen
Resolution
Expansion
(H: Horizontal)
(V: Vertical)
Display
Resolution
640 × 400 24.827 56.420 21.053
× 1.6(H)
× 1.92(V)
1024 × 768
640 × 400 31.469 70.000 25.175
640 × 480 31.469 59.992 25.175
× 1.6640 × 480 37.500 75.000 31.500
640 × 480 35.000 66.670 30.240
720 × 400
*1
*1 When you use this resolution, set “ON” for “720 × 400 Mode” in the OSD (On Screen Display)
system settings.
31.469 70.000 28.320
× 1.42(H)
× 1.92(V)
800 × 600 37.879 60.317 40.000
× 1.28
800 × 600 46.875 75.000 49.500
1024 × 768 48.363 60.004 65.000
× 1.01024 × 768 56.476 70.069 75.000
1024 × 768 60.023 75.029 78.750