Manual

After changing both backlights, be sure to check that screen operates correctly. If a prob-

lem occurs, contact your local GP distributor.

3) Disconnect the upper backlight's power

connector.

5) Remove the old backlight.

4)Loosen the upper and lower backlight

holder attachment screws, and remove the

upper backlight unit's metal cover.

Since the attachment screws are small,

be sure not to lose them or allow them

to fall inside the GP's case.

• Be sure not to pinch or cut any of the GP's internal wiring when closing the case.

• If any of the attachment screws becomes misplaced, check to be sure that they have not

fallen inside the GP. If a screw has fallen inside the GP, do not connect the unit’s power cord.

6) Insert the new backlight.

Upper Section

Lower Section

Attachment Screws

9) After both backlight units are changed and the power connectors reattached, close

the rear case and reattach the case's two attachment screws.

8) Reattach the backlight unit's power connector. Repeat these steps for the GP's bot-

tom backlight unit.

If the backlight has

an arrow here, it is

used only for the

upper backlight.

7) Insert the metal cover's three (3) position-

ing tabs into the backlight holder’s posi-

tioning slots. Next, insert and tighten the

cover's two (2) attachment screws.

Positioning Tabs

The GP’s upper and lower backlights

are different. Be sure to confirm that

the backlight you are replacing is the

correct unit by looking at the side of

the backlight connector.