- CEM GLobal Burner User Manual

Limpieza
1. Apague las hornillas girando su perilla de control a la posición de OFF.
2. Siempre desconecte la unidad del tomacorriente y permita que se enfríe antes
de limpiarla.
3. NUNCA SUMERJA LA UNIDAD EN AGUA NI OTROS LÍQUIDOS.
4. Los quemadores están sellados para facilitar su limpieza. No intente sacar los
quemadores de la unidad.
5. Use un paño o esponja húmeda y jabonosa para limpiar la superficie de las
hornillas y sus anillos, patas y casco de la unidad. NUNCA USE MATERIALES
ABRASIVOS EN PARTE ALGUNA DE LOS QUEMADORES.
6. Frote las hornillas y sus anillos con un paño para eliminar el jabón y déjelas
secar.
7. Esta hornilla no contiene piezas a las cuales se les pueda dar servicio. Cualquier
servicio aparte de la limpieza debe realizarlo un centro autorizado.
NOTA: Se provee un cordón de suministro eléctrico corto para reducir los riesgos de
enredarse o tropezarse con un cordón largo. Si se requiriese un cordón más largo,
hay cordones de extensión disponibles que pueden usarse si se tiene cuidado.
Si se usa un cordón de extensión, asegúrese que: (1) la marca de su capacidad
eléctrica por lo menos sea igual a la carga eléctrica de la cocina (120V, 750W)
y; (2) tienda el cordón de modo que no cuelgue del mostrador o la mesa para que
los niños no tiren de éste o las personas no se tropiecen accidentalmente. Si el
enchufe no encaja en forma segura en un tomacorriente de CA o el tomacorriente
se calentase, no use este tomacorriente.
Un cuidado razonable de la hornilla asegurará muchos años de servicio. Evite
dejar caer artículos sobre las hornillas selladas o sus anillos.
CLEANING
1. Turn Temperature Control Knob(s) OFF.
2. Always unplug unit from electrical outlet and allow to cool before cleaning.
3. NEVER IMMERSE UNIT IN WATER OR OTHER LIQUIDS.
4. Do not attempt to separate burner from the unit.
5. Use a damp, soapy cloth or sponge to clean the surface of the sealed burners,
burner rings, legs, and housing unit. NEVER USE HARSH ABRASIVE OR STEEL
WOOL PADS ON ANY PART OF THE BURNER.
6. Thoroughly wipe soap from sealed burners and burner rings. Then dry.
7. There are no user serviceable parts. Any servicing other than cleaning should be
performed by an authorized service center.
NOTE: A short power supply cord is provided to reduce the hazards resulting from
becoming entangled in or tripping over a longer cord. If a longer cord is required,
extension cords are available and may be used if care is exercised in their use. If an
extension cord is used, (1) the marked electrical rating of the extension cord should
be at least as great as the electrical rating of the Single Burner (120V, 750W) and
(2) the longer cord should be arranged so that it will not drape over the countertop
or tabletop where it can be pulled on by children or tripped over unintentionally.
If the plug does not fit securely into the AC outlet or if the AC plug or outlet feels
warm, do not use that AC outlet.