Specifications

10
This in addition to the Mjr’s ability to operate under high humidity conditions
makes it perfect for harsh field conditions.
INTERFACING
A. TO BETACAMS:
The PSC Mjr Mixer is especially designed for easy interfacing with all popular
Betacam type cameras. The Mjr is equipped with a 10 pin Hirose tm connector
on the rear panel. This all-inclusive connector provides both left and right
balanced outputs and tape returns. Pin Outs are as follows:
Pin 1 Left Output High
Pin 2 Left Output Low
Pin 3 Right Output High
Pin 4 Right Output Low
Pin 5 Left Tape Return
Pin 6 Tape Ground
Pin 7 Right Tape Return
Pin 8 Tape Ground
Pin 9 Ground
Pin 10 Ground
PSC manufactures a selection of standard Beta Snake cables for use with the
new Mjr Mixer. Please note that the Mjr Mixer and M4mkII Mixers use the same
cables. These cables are available in standard and camera breakaway versions
from any authorized PSC dealer. Part numbers are as follows:
FPSC1091M4A 15’ (4.5M) Standard
FPSC1091M4B 15’ (4.5M) Breakaway
FPSC1091M4C 25’ (7.5M) Standard
FPSC1091M4D 25’ (7.5M) Breakaway
B: TO RDAT RECORDERS:
The M4mkII Mixer can be interfaced to virtually any professional recorder via the
10 pin Hirose tm connector. If desired, you can also use the tape return
function.
C: TO WIRELESS MICROPHONES:
The Mjr Mixer will easily accept the output signal from virtually any wireless
receiver. It can accept microphone or line level signal via a simple switch setting.
Please note that most wireless receivers are not compatible with 48PH mic
power. You should always set the Mjr’s mic powering switch to “D” dynamic
when using wireless receivers.