Instructions

3
Do not expose the start device is not high or very low temperatures, strong vibrations or humidity.
Always look for a safe placement of the device! The start device must be securely installed / placed so that
it does not fall down or fall over.
The device is not a toy. It does not belong in the hands of children.
In industrial facilities, the safety regulations of any relevant professional association are observed.
Caution! Working in the vicinity of lead-acid batteries is dangerous! Batteries emit explosive gases during
operation and loading at startup help! Always suitable clothing, gloves and safety goggles when working
on a battery!
Battery acid is corrosive! Possibly. Thoroughly acid splashes immediately with plenty of water and seek
medical advice. If battery acid gets in the eyes, immediately wash out at least 10 minutes under running
water, seek medical attention.
Never smoke near the battery, or use open flames, sparks and avoid sparks!
With the included charger only this start device must be loaded. Do not use another charger to charge
the booster unit. The use of accessories or attachments, that are not recommended by the
manufacturer may cause damage to the unit or injury to personnel, and! In addition,
the warranty expires!
To avoid damage to the terminals and the instrument, never pull on the cable,
always using connector / terminal disconnect the jumper connection.
The charging and jump start cables must be in good condition. Lines are damaged,
do not use start device. First device repaired by an authorized technician.
Any flammable objects such as Leave candles on the apparatus. No objects filled
with liquids, such as Water containers, beverage containers on the device or turn
around. Only undamaged batteries support. Ensure a sufficient level of liquid in the battery (open lead-
acid batteries). Note the Hinwiese the battery / vehicle manufacturer. These can be found in the accompa-
nying document, the log of your vehicle. Or, contact the battery manufacturer. Never remove the battery
clamps while jump starting! Not short circuit terminal clamps! First connect to the battery terminal clamps
in the correct polarity, then hitting jump start switch. Clean the battery terminals and connectors on the
vehicle only.
Work. For your protection and security are not alone or at least so that another person is always within
calling distance Personal metallic objects (such as rings, cuffs and necklaces, watches) before working on
the starter Remove the battery to prevent accidental short-circuit Short-circuit voltages as Melt rings and
so cause severe burns.
4
2 Scope of delivery
1 start device
1 Charger 230V / 12V
1 Car Charger 12V (not included with JPR1800)
1 set of jumper cables with connectors
1 storage bag
1 12V connection cable (only device JPR9000)
1 User manual
1 Fully recyclable retail packaging.
3 Intended use
This jump starter provides additional support for the 12V vehicle battery startup problems in vehicle en-
gines. As far as this by a weak or defective
Vehicle battery caused. The start device can not replace the vehicle battery.
Use the start device not as a starter battery replacement, EXPLOSION!
Connect the start device exclusively with the battery. No contact with the
Making body! The vehicle electrical system could be damaged.
Do not let the booster unit and do not burden the body with additional devices
Weight, you put the device to shock or severe vibration, protect the unit from heating up, put the device
or check the device in flames, keep it always dry, submerge it in liquids one, pour never spill liquids on the
start device. LIONS EXPO DANGER!
Use of the booster unit is permitted only in dry areas or dry conditions. Contact with moisture, such as fog,
rain, snow, Kondensnässe etc. must be avoided. Any use other than that described above will damage the
product and is also associated with dangers like short-circuit, burns, electric shock, etc.. The entire product
and its accessories may not be changed or modified, the device housing not be opened! Observe these
safety instructions!
4 Technical Features / Amenities
This start device is equipped with a high quality lithium battery. The device can be as light and compact,
use anywhere to help launch or as a power charger for USB devices. Avoid high ambient temperatures.
Lithium batteries should be kept cool. Overheated up vehicle interiors and high ambient temperatures
should be avoided. Store the device therefore not in the vehicle. Minus ambient temperatures have a sig-
nificant influence on the battery capacity. This is greatly reduced in cold weather. Therefore, do not store
or winter, the start device in the vehicle.
The input voltage of the supplied charger voltage corresponds to the household. (230V AC 50Hz) Output
power is 1A.
Finally, always use the power values __of the jumper and the connected device to support battery.
(See table in the appendix to use this manual) Only rechargeable 12V lead-acid batteries are suppor-
ted! The jump starter is suitable for all lead-acid for GEL, AGM and - batteries. Depending on the device
version for 6V or 12V batteries. Other types of batteries and battery voltages must not be connected to
the emergency starter.
axhess GmbH & Co. KG, Industriestrasse 11, 56598 Rheinbrohl, www.axhess.de