OWNER’S MANUAL S10 / S8 Powered Subwoofers
SAFETY INSTRUCTIONS APPLICABLE FOR USA, CANADA OR WHERE APPROVED FOR USAGE CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE PLUG TO WIDE SLOT, INSERT FULLY. CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel. ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU AU FOND.
INSTALLATION Voltage Selector (See Figure 1) For use in the U.S., the S10 / S8 comes preset from the factory at 115V. For use in other countries, the voltage may be set at 230V. (Please note that an outlet adapter or alternate power cord may be required.) Figure 1: Voltage Selector Connecting the Line Level Audio Inputs (See Figure 2) If your surround sound receiver or amplifier has only one subwoofer output, simply plug it into the Left Line Input.
SPEAKER SPECIFICATIONS S10 S8 System Configuration: Vented Powered Subwoofer Vented Powered Subwoofer Woofer: 10" Long Excursion Treated Paper Cone Woofer with Butyl Surround 8" Long Excursion Treated Paper Cone Woofer with Butyl Surround Ports: Dual Ports to Eliminate Vent Noise and Distortion Dual Ports to Eliminate Vent Noise and Distortion Frequency Response: 32Hz - 200Hz 45Hz - 200Hz Power: 120 Watts RMS; 160 Watts Peak 80 Watts RMS; 120 Watts Peak Hook Ups: RCA Line Level and Speaker
