Operation Manual

ELECTRICAL CONVECTOR HEATER EN - 1
PCL-300 Standard Sirocco
PCL-303 with ventilation Mistral
We thank you for the purchase of this Profile product.
Note: It is important that you read this manual before
using the product. And be sure to save this manual for
possible use later.
Technical information
 Mains voltage: 220V – 240V AC (50Hz)
Power: - In position 0  OFF
- In position 1  750W
- In position 2  1250W
- In position 3  2000W
 IPX0 (no protection against water)
 Overheat protection
 Frost protection
 Variable, built-in thermostat
 ON/OFF switch
 With handle for easy moving
 Ideal for usage in dry areas up to a maximum of
60m³.
 Can be used freestanding or wall-mounted
Safety precautions
 To ensure safe operation of your heater, the appliance
must be assembled and connected in accordance with
the indications in the manual. When these instructions
are ignored, the liability of the supplier/manufacturer
becomes null.
 The appliance is only suitable for domestic use within
the home.
 Do not use the appliance in humid spaces, such as
bathrooms and utility spaces.
 When the heater is covered, then this can result in a
fire hazard.
 Place the appliance only upright and on a level, dry
base.
 Do not use the appliance without the feet fitted or
when fitted incorrectly.
 The surfaces, and especially the grate, become very
hot during operation. Make sure that small children
cannot touch these surfaces.
 No objects may be inserted through the appliance's
grate opening. This can disrupt the working of the
heater and burn the object, or even cause danger of
electrocution.
 Never use the appliance in combination with a time
switch. The automatic operation of heaters can result
in a hazard during your absence.
 Never leave your appliance unattended. Also always
pull the plug out of the socket when you leave the
room.
 Do not run the mains lead across the hot appliance.
 Electrical heaters are designed as additional heating
and are not suitable for main heating during the cold
season.
 When the appliance has fallen, then first disconnect
the power supply, before returning the appliance to its
upright position and if necessary remove what caused
it to fall.
 Position the heater at a distance of at least 100cm
from obstacles and ensure that the hot air flow of
the appliance is not blown against any easily
combustible objects (such as curtains and/or heat-
sensitive plastics).
 Do not use an extension lead.
Connection
The heater is supplied with a socket plug. Never
operate the appliance with a damaged mains lead
and/or plug, or after a malfunctioning of the heater has
occurred or after it has been damaged in any possible
way.
The replacement of a mains lead and/or plug should
only be performed by a qualified expert, who is familiar
with the applicable regulations.
Installation
Freestanding:
 Carefully turn the radiator on its side to fit the feet.
 Attach all feet (fig.1) and secure them by means of
the included screws.
 Every foot requires 2 screws. Do not use the radiator
with the feet incorrectly fitted!
Fig. 1
Wall-mounted:
You can also mount this heater on to the wall, using
the 2 included wall supports.
 Respect the minimum distance from objects.
 Drill 2 holes into the wall with a horizontal distance
of 418mm between them for the upper wall support
and insert the included plugs. Make sure that you
install the heater straight up.
 The lower wall supports must be attached on the
lower corners of the appliance; use for this the
holes that were originally intended for the
attachment of the 2 feet. If necessary, these lower
supports can also be attached to the wall.
Operation and functions
Operation:
 Put the wattage switches in position 0.
 Insert the plug into the wall socket.