Operation Manual

HALOGEN HAND LAMP BASIC EN - 2
PLI-130
Technical information
 Working voltage: 230V AC (50/60 Hz)
 Maximum lamp power: 500W.
 Maximum current strength: 10/16A.
 Dustproof and splashproof: IP44.
 Passive infrared sensor (PIR).
 Sensor angle: 120°.
 Sensor range: 10 metres at with 25°C.
 Lighting time: +/- 5 sec. – 10 min.
Setting the functions
1) Setting the light intensity (lux)
With the LUX Switch you adjust the working of
the sensor to match the intensity of the
ambient light.
If the arrow is pointing to the sun the sensor
responds in both daylight and at night.
If the arrow is pointing to the moon the sensor
will only respond at night.
In between the sensor responds in half-light.
2) Setting the lighting time (TIME)
With this adjusting knob you can set the period
of the light staying on after switching on. You
can set the time from 5 sec. to 10 min.
Continuous function
With this function you can allow the lamp to
stay on continuously (the sensor then no
longer works).
To do this switch the switch the fitting is
connected to on and off for 1 second. The
lamp will now stay on continuously.
To switch off the continuous function switch the
switch the fitting is connected to off for 30
seconds and then on again.
Maintenance
 Only use a dry, soft cloth for cleaning the
halogen hand lamp. And make sure that the
lamp has first cooled.
 Never immerse the lamp in water.
 Maintenance and repairs may only be carried
out by technicians who are familiar with any
applicable regulations.
Guarantee conditions
The
guarantee period for PLI-130 amounts to 2
years and commences on the date of
purchase. During the guarantee period ELTRA
nv will repair any defects attributable to
material or production faults. ELTRA NV may
choose to either repair or replace a defective
appliance.
ELTRA NV is not obliged to repair or replace
appliances if they have become defective as a
result of damage, inappropriate use, or
modifications or adaptations made after the
purchase date.
Take any defective appliance together with the
original receipt back to the shop where the
appliance was sold. Always add a note with a
description of the problem.
Damage
ELTRA NV can under no circumstances
whatsoever be held responsible for damage of
whatever nature if the appliance was not
correctly installed according to the specified
installation instructions, nor for damage as a
result of unforeseen circumstances such as
natural disasters, lightening strike, etc. All such
resulting costs are consequently at the
expense of the buyer and are not covered by
the guarantee conditions.
www.profile.eu
Eltra nv, Pachtgoedstraat 2, 9140 Temse, BELGIUM
Eltra DIYeuronet, Frontstraat 14, 5405 AM Uden,
THE NETHERLANDS