Instructions / Assembly
INSTALLATION INSTRUCTIONS
1
2
3
Clear the installation area of
grass, loose soil, and debris. Slide
edging pieces together so
anchoring tabs overlap.
Hammer spikes through tabs at the
ends of the installation and
connection points. Additional
spikes are available separately.
Backll with mulch, river rock, or
other ground cover. Assure tabs
are completely covered with a
thick layer of bedding material.
Always use proper safety precautions when cutting and spiking edging.
Protective eyewear and gloves are recommended during installation.
CONNECTION SYSTEM
Overlapping post
system stabilizes and
strengthens joints.
Site Preparation:
Soil must be solid and level. Assure there is no debris
between the edging tab and the dirt below. Compact
the cleared soil prior to installation to reduce spike
movement from shifting ground and frost heave.
Weed fabric can minimize the spread of invasive
weeds and grass. Install fabric according to product
directions, then place the landscape edging over the
fabric and hammer spikes through the tabs
and fabric.
Installation:
Enough anchoring spikes are included to
accommodate typical installations. Certain conditions
and landscape designs can require additional spikes,
which are available in stores and online.
Anchoring spikes should be hammered only to the top
of the edging tab. Hammering the spike to the point
the tab bends can damage the edging.
Generously cover tabs with soil and groundcover.
Heavy bedding materials such as rock and mulch
tend to perform best.
Interlocking anchoring
tabs eliminate separate
connection pieces.
Seamless connection creates
uninterrupted borders.
3600_4.19
HELPFUL TIPS & INFORMATION