Specification Sheet

Product Features
• Durable easy-care acrylic
construction
• Six fully adjustable color matched
hydro jets including lumbar jets
• Powerful 7.8 amp pump/motor
• Pre-leveled base for easy
installation
• Factory preset air controls for
whirlpool action
• Textured slip resistant bottom
• Electronic on/off switch
• Heater blank, safety suction and
silent air induction
• Available as an invigorating
whirlpool and an unjetted
soaking bath
General Specifications
• 70” length overall
• 40” width overall
• 20 1/2” depth overall
• 50 gallon operating capacity
• 75 gallon total capacity to overflow
• Electrical service requirements:
Motor 120 V., 20 A., 50/60 Hz.,
Single Phase, Class B Insulation
• Ground fault circuit protection
must be provided by installer
• Prewired for simple plug-in
installation
PFW7040PLUSWH
70 x 40 Plus Series
Whirlpool & Soaking Baths
Warranty and Codes
This product features a 5-year limited warranty and meets or
exceeds the following standards: Whirlpools - IAPMO PS32-84,
UL listing 27E7, ANSI Z124.1-95, ASME A112.19.8M-87R(96)
and ASME A112.19.7M-95. Baths - ANSI Z124.1-95. In an
effort to continually improve our products, design changes may
periodically be made. Ferguson reserves the right to provide
newly designed material to fill any order unless otherwise
agreed to in writing.
Model Numbers
PFW7040PLUS 70” x 40” acrylic oval whirlpool
PFS7040 70” X 40” acrylic oval soaking bath
MIRPRESSHTR Whirlpool heater
NOTE: All dimensions and specifications are nominal and may vary ±
1
⁄4 ”.
Use actual products for accuracy in critical situations.
Product Specifications
Construction
This PROFLO Whirlpool is constructed of the highest-grade
acrylic and reinforcement composites available. The plumbing
system utilizes high-pressure air and waterway tubing and each
joint is solvent welded and pressure tested. Each unit is leveled
and performance tested before leaving the factory.
Color Palette
• White - WH
• Biscuit - BS
© 2007 Wolseley 0333 10/07