Installation Sheet

PROFLO.COM 11
CARE AND CLEANING
The use of bath oils and bath salts is not recommended due to the difculty in cleaning the systems and doing so will void the
consumer’s warranty.
Pump and pipe circulation system should be ushed before rst use and on a monthly basis when product is under normal use.
Below are the recommended procedures for cleaning:
DO NOT use powdered cleaners unless cleaner is fully dissolved in water.
DO NOT RUN WHIRLPOOL DRY. Fill the tub with hot water 2-3 inches above the jets and add 2-3 teaspoons of low foaming
detergent such as dish washing machine detergent.
DO NOT use full strength bleach of ammonia cleaning solutions. Chemically active cleaning solution can damage the bath surface.
• Switch on whirlpool and run for 10 minutes.
• Drain tub completely.
• Fill tub with cold water above jets.
• Switch on whirlpool and run for 5 minutes.
• Drain tub completely.
DO NOT USE ABRASIVE CLEANERS as they will scratch and dull the surface of the acrylic and void the consumer warranty. Plaster
can be removed using a sharpened wooden stick.
DO NOT USE METAL SCRAPERS, WIRE BRUSHES OR OTHER HARSH ABRASIVE TOOLS.
Usually a mild detergent will remove construction debris. More stubborn debris may be removed with denatured alcohol, or Clorox Soft
Scrub
®
cleaner. Light scratches and dulled areas may be restored to original luster by rubbing with an automotive type cleaning com-
pound such as DuPont White Polishing Compound
®
.
Note: To restore dull or scratched units: Apply white automotive polishing with a clean rage. Rub scratches and dull areas vigorously.
Wipe off residue. Follow with a coat of white automotive paste wax.
DO NOT wax areas where you walk or stand. For crack and major surface damage, call customer service at 1-800-221-3379 for
repair recommendations.
OPERATING INSTRUCTIONS
1. Fill the bath to at least 3 inches above the jets before activating the pump. DO NOT turn on whirlpool unless jets are completely
submersed in water.
2. If any factory installed ttings are removed; do not operate the unit. A safety hazard may occur.
3. Do not use bubble bath when you operate the whirlpool pump. This might cause excessive foaming.
4. Bath oils should not be used when you operate the whirlpool. If used while soaking, please drain and clean the tub thoroughly prior to
activating the whirlpool system.
5. The use of bath salts is not recommended and doing so will VOID THE CONSUMER’S WARRANTY.
6. Whirlpool systems are plumbed in a way that water will drain from the plumbing easily.
7. There are no user serviceable parts located under the tub. If a problem develops, call 1-800-221-3379