Installation Sheet

PROFLO.COM 9
Use drawing below as a guide for rough-in measurements
Deck-to-oor dimensions are measured through the drain hole to give a more consistent measurement. The dimensions are achieved by
laying a straight edge across the deck; the distance was then measured from the oor at the drain opening to the bottom of the straight
edge. (See illustration below). The lip height is then subtracted to give a more consistent oor to lip height. There may be height dimension
variations of plus minus ¼" from the stated dimension in the table, which is a standard production tolerance. Leave adequate clearance with
framing for side mounted controls.
D
B
L
W
A
H
L
L
L
L
L
B
B
B
A
A
A
A
W
W
W
C
W
W
B
D
B
L
W
A
H
L
L
L
L
L
B
B
B
A
A
A
A
W
W
W
C
W
W
B
Height
to Top
Height
to Deck
Tape Measure
Straightedge or Wood Board
Floor
Measure from
Straightedge to Floor
Through Drain
O