Owner's Manual

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptoms that apply, and

follow the steps listed. If further assistance is needed, please see the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a properly grounded outlet (see page 9). Use only a single-outlet surge suppressor

that meets all of the specifications described on page 9. Important: The treadmill is not compatible

with GFCI-equipped outlets.

b. Make sure that the key is inserted into the console.

c. Check the reset/off circuit breaker located on the frame near the

power cord. If the switch protrudes as shown, the circuit breaker has

tripped. To reset the circuit breaker, wait for five minutes and then

press the switch back in.

PROBLEM: The power turns off during use

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If

the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for

five minutes, and then plug it back in.

c. Remove the key from the console and then reinsert it.

d. Make sure that the reset/off circuit breaker is in the on position (see 1. d. above).

e. If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 9.

b. If the walking belt is overtightened, treadmill performance

may decrease and the walking belt may be permanently

damaged. Remove the key and

UNPLUG THE POWER

CORD. Using the included allen wrench, turn both rear

roller bolts counterclockwise 1/4 of a turn. When the

walking belt is properly tightened, you should be able to

lift each edge of the walking belt 3 to 4 inches off the

walking platform. Be careful to keep the walking belt cen-

tered. Plug in the power cord, insert the key and run the

treadmill for a few minutes. Repeat until the walking belt

is properly tightened.

c. If the walking belt still slows when walked on, see the front cover of this manual.

Rear Roller Bolts

3–4”

Reset

Tripped