Owner's Manual

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.

Assembly requires two persons. Place the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until the treadmill is assembled.

ote: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a

small amount of lubricant may be transferred to the top of the walking belt, the sides of the walking platform, or

the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt or

on the sides of the walking platform, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires a phillips screwdriver and the included allen wrench .

1. With the help of a second person, carefully raise the

Uprights (65) to a vertical position.

Have the second person hold the console assembly near

the Uprights (65) as shown. Look under the console as-

sembly and locate the Console Wire Harness (71).

Cut the plastic ties securing the Upright Wire Harness

(85) to the right Upright (65). Next, connect the Upright

Wire Harness to the Console Wire Harness (71). Make

sure to connect the connectors properly (see the

inset drawing). The connectors should slide together

easily and snap into place. If the connectors do not

slide together easily and snap into place, turn one con-

nector and try again. IF THE CONNECTORS ARE NOT

CONNECTED PROPERLY, THE CONSOLE MAY BE

DAMAGED WHEN THE POWER IS TURNED ON.

2. Insert the Wire Harnesses (71, 85) into the right Upright

(65).

Set the console assembly on the Uprights (65). While a

second person holds the console assembly, attach the

console assembly with four Console Bolts (70) and four

Console Washers (69) as shown. Note: Start all four

Console Bolts before firmly tightening them.

Console

Assembly

Console

Assembly

71, 85