Owner's Manual

13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be

left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the

elliptical exerciser.

12. See the upper drawing. See HOW TO PLUG

IN THE POWER CORD on page 12 and plug in

the Power Cord (133). Next, make sure that the

eset/Off Switch (37) is in the “reset” position.

ee the lower drawing. Press the Quick Power

Ramp 10º button on the Console (not shown).

The Ramp (4) will then move downward to the

lowest incline level.

IMPORTANT: If the Ramp (4) does not move

all the way downward to the lowest incline

level, see HOW TO CALIBRATE THE RAMP

on page 23 and manually calibrate the

Ramp.

Attach the Upright (6) to the Frame (1) with four

5/16" x 1" Patch Screws (81) and four 5/16"

Split Washers (105).

133

105