Owner's Manual

15
HOW TO TURN ON THE POWER
IMPORTANT: If the elliptical exerciser has been
e
xposed to cold temperatures, allow it to warm to
room temperature before turning on the power. If
y
ou do not do this, you may damage the console
displays or other electrical components.
Plug in the power cord (see
HOW TO PLUG IN THE
POWER CORD on page
12). Next, locate the
reset/off switch on the frame
near the power cord. Make
sure that the reset/off switch
is in the reset position.
The display will then light and the console will be
ready for use.
HOW TO USE THE MANUAL MODE
1. Begin pedaling or press any button on the
console to turn on the console.
See HOW TO TURN ON THE POWER above.
2. Select the manual mode.
Each time you turn on the console, the manual
mode will be selected.
If you have
selected a workout,
reselect the man-
ual mode by press-
ing any of the
Workouts buttons
repeatedly until the
word MANUAL appears in the lower left corner of
the display.
3. Change the resistance of the pedals and the
incline of the ramp as desired.
As you pedal,
change the resis-
tance of the pedals
by pressing one of
the numbered
Quick Resistance
buttons or by
pressing the Quick Resistance increase and
decrease buttons located on the console or on the
right upper body arm.
Note: After you press the buttons, it will take a
moment for the pedals to reach the selected resis-
tance level.
To vary the motion of the pedals, you can change
the incline of the ramp. To change the incline,
press one of the numbered Quick Power Ramp
b
uttons or press the Quick Power Ramp increase
and decrease buttons located on the console or on
t
he left upper body arm.
Note: After you press the buttons, it will take a
moment for the ramp to reach the selected incline
level.
4. Follow your progress with the display.
The console offers several display modes. The
display mode that you select will determine which
workout information is shown. Press the Display
Mode button repeatedly to select the desired dis-
play mode.
The displays can show the following workout infor-
mation:
Time—When the manual mode is selected, this
display will show the elapsed time. When a work-
out is selected, the display will show the time
remaining in the workout instead of the elapsed
time.
Pace—This display will show your pedaling pace
in revolutions per minute (RPM).
Distance—This display will show the distance
(total number of revolutions) you have pedaled.
Calories—This display will show the approximate
number of calories you have burned.
Pulse—This display will show your heart rate
when you use the handgrip pulse sensor (see step
5 on page 16).
Reset
Position