Owner's Manual

HOW TO ADJUST THE DRIVE BELT

If you can feel the pedals slip while you are pedaling,

ven when the resistance is adjusted to the highest

level, the drive belt may need to be adjusted.

To adjust the drive belt, you must first remove the

screws attaching the left shield (see the instructions

below).

Remove the indicated #8 x 3/4" Screws (78) from the

Right and Left Shields (38, 39). Then, gently pull the

Left Shield away from the frame.

Next, loosen the Pivot Screw (128). Then, tighten the

Drive Belt Adjustment Screw (118) until the Drive Belt

(57) is tight. Note: For clarity, the left shield and the

eft pedal disc are not shown in the drawing below;

however, it is not necessary to remove these parts.

When the Drive Belt (57) is tight, tighten the Pivot

Screw (128).

Then, reattach the left shield.

128

118