Owner's Manual

1. Make sure that the power cord is unplugged.

With the help of a second person, carefully tip

the treadmill onto its left side. Partially fold the

Frame (55) so that the treadmill is more stable;

do not fully fold the Frame yet.

Locate the Upright Wire (85), which is bundled

at the back of the Base (94). Remove the pack-

aging from the Upright Wire. Next, insert the

Upright Wire into the Base, and pull it out of the

indicated hole. If necessary, use the plastic tie to

pull the Upright Wire out of the hole.

Next, hold a Wheel (95) inside of a Wheel

Housing (96). Insert a Wheel Axle (97) into the

Wheel, and press the Wheel Housing into the

Base (94). Make sure that the tab on the

Wheel Housing is in the position shown.

Attach the other Wheel (95) in the same way.

Tab

2. Attach the four Base Feet (92) to the Base (94)

in the locations shown with four #8 x 1" Tek

Screws (2).

See the inset drawing. Cut the plastic tie near

the Upright Wire (85).

Hole

Tie

Cut

Tie