Owner's Manual

24
HOW TO MAINTAIN THE EXERCISE BIKE
Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, the drive belt
may need to be adjusted.
See the EXPLODED DRAWING on page 27 to identify
the parts mentioned below.
To adjust the Drive Belt (66), first press the power
switch to the off position and unplug the power
cord.
Use a flat screwdriver and remove the Upper Shield
(10) and the right Shield Cover (13).
Next, remove the #8 x 32 x 13mm Screw (88) from the
Right Shield (12). Then, remove the #8 x 3/4" Screw
(94) from the Left Shield (11).
Then, use a socket set to remove the two 1/4" Flange
Nuts (99) from the Right Shield (12).
Remove the two #8 x 1/2" Screws (95) on the right
s
ide of the Electronics Shield (98). Then, gently move
the Right Shield (12) away from the exercise bike.
Locate the Idler Pulley (37). Loosen the 3/8" Jam Nut
(71). Then, tighten the Idler Adjustment Screw (39)
until the Drive Belt (66) is tight.
When the Drive Belt (66) is tight, tighten the 3/8" Jam
Nut (71).
Reattach the Right Shield (12) with the #8 x 1/2”
Screws (95), the 1/4" Flange Nuts (99), the #8 x 3/4"
Screw (94), and the #8 x 32 x 13mm Screw (88).
Then, reattach the Upper Shield (10).
MAINTENANCE AND TROUBLESHOOTING