Hydrotherapy Spa Patent Pending Model No. 831.210051 Serial No. Write the serial number in the space above for reference. The serial number decal is on the frame behind the access cover. USERÕS MANUAL QUESTIONS? PLEASE CALL DIRECT TO OUR TOLL-FREE CUSTOMER HOT LINE. The trained technicians on our customer hot line will provide immediate assistance, free of charge to you. CUSTOMER HOT LINE: 1-800-999-3756 Mon.ÐFri., 6 a.m.Ð6 p.m.
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 CHOOSING A LOCATION FOR THE HYDROTHERAPY SPA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7 SET-UP AND ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IMPORTANT SAFETY INSTRUCTIONS WARNING: TO REDUCE THE RISK OF DROWNING, ELECTRIC SHOCK, OR SERIOUS INJURY, READ THE FOLLOWING IMPORTANT PRECAUTIONS BEFORE USING THE RESTORATION 5.1. READ AND FOLLOW ALL INSTRUCTIONS 1. It is the responsibility of the owner to ensure that all users of the hydrotherapy spa are adequately informed of all precautions. 9. Do not bring any object into the hydrotherapy spa that could damage the spa shell. 10. Never insert any object into any opening. 2.
20. DANGERÑIf you will be using the hydrotherapy spa outside, do not bury the power cord; you should also keep the power cord away from lawn mowers, hedge trimmers, and other similar equipment. 27. DANGERÑRisk of drowning: Exercise extreme caution to prevent unauthorized and unsupervised use of the hydrotherapy spa by children. Children must always be supervised. 21. WARNINGÑThe hydrotherapy spa must be wired directly into a 240 volt power source equipped with a Ground Fault Circuit Interrupter (GFCI).
34. WARNINGÑTo reduce the risk of injury or drowning: Consult your physician about possible side-effects of any medications you may be taking before using the hydrotherapy spa. Heat from the water, in conjunction with some medications may cause drowsiness and increase the risk of drowning. Others can effect blood pressure, heart rate, and circulation. 36. If you feel pain or dizziness at any time while using the hydrotherapy spa, discontinue use and contact a physician. 37.
BEFORE YOU BEGIN Thank you for selecting the innovative PROFORM¨ RESTORATION 5.1 hydrotherapy spa. The RESTORATION 5.1 hydrotherapy spa offers the features and quality of a traditional hot tub at an affordable price. Best of all, the RESTORATION 5.1 hydrotherapy spa provides the benefits of hydrotherapy in the comfort and privacy of your own home. Hydrotherapy is a proven method for soothing tired muscles after exercise or for relieving the stress of a busy life.
CHOOSING A LOCATION FOR THE HYDROTHERAPY SPA There are many factors to consider when choosing a location to set up the hydrotherapy spa. These factors vary depending on whether you use the hydrotherapy spa inside or outside. We have listed several factors you may wish to consider as you decide where you want to use the hydrotherapy spa. If you set up the hydrotherapy spa inside: If you set up the hydrotherapy spa outside: 1. The hydrotherapy spa will increase the level of humidity in your home.
SET-UP AND ASSEMBLY Before beginning assembly, carefully read the following information and instructions: ¥ Read each assembly step before you begin. ¥ Tighten all parts as you assemble them, unless instructed to do otherwise. ¥ Place all parts in a cleared area and remove the packing materials from the spa shell; do not dispose of the packing materials until assembly is completed and the spa is in operation. ASSEMBLY REQUIRES THE FOLLOWING TOOLS (not included): ¥ Assembly requires two people.
3. Place the Spa Cover (18) over the spa. Be sure that the Spa Cover is properly centered. 3 Strap Latch Snap a Buckle (2) onto each of the four latches on the Spa Cover (18). 2 15 See the inset drawing. Position one of the Buckles (2) on the wood panels on the Spa Unit (15). Hold the Buckle in place so the strap on the Spa Cover (18) is tight. (Note: It may be easier to position the Buckle if a second person holds the strap on the opposite side of the Spa Cover tight.) The Spa Cover must be tight.
WIRING THE RESTORATION 5.1 The RESTORATION 5.1 is designed to operate with a 240 volt AC power source; it must be wired by a qualified electrician directly into a 240 volt AC GFCI in your home. The steps below are intended to be used as a reference for the qualified electrician who wires your spa and installs the 240 volt AC GFCI in your home. WARNING: Only a qualified electrician should perform this procedure. 1.
5. For a 40 amp 240 volt AC power supply, set the jumper J1 to pins 1 and 2 on the power board and leave the other jumpers at the factory settings, as shown at the right. This will allow the heater and the pump to operate at high speed simultaneously. 5 Jumper settings for a 240 volt AC, 40 amp power supply 6. Secure the power cord by tightening the screws in the wire clamp on the Control Unit (14). 6 14 Screws Power Cord Wire Clamp 7.
USING THE HYDROTHERAPY SPA The hydrotherapy spa is designed to seat five adults. The fifteen thera-jets can be regulated to provide a relaxing massage to sooth away stress, and the strength of the water massage can be adjusted by the air control. The hydrotherapy spa holds 200 gallons of water and offers an automatic, programmable heating (41¡F to 104¡F) and filtration system. If the level is too low, add half of one of the ÒQUICK pHix It UPÓ packets to the water.
SPA SHELL DIAGRAM G A C A B E F D B B A D A A SPA OPERATION Refer to the diagram above. The function of each component is explained below: The suction vents (D) located near the floor of the spa brings the water into the pump in order to operate the system. The suction covers should always be in place over the suction vents. Never operate the spa without the suction covers in place. The eight uni-directional thera-jets (A) are located on both sides of the spa.
CONSOLE DIAGRAM USING THE CONSOLE Filter On: This LED indicator is lit when the spa is running the filter cycle. Refer to the console diagram above. The function of each console control is explained below: Note: To keep the heat and filter cycles from running, shut off the circuit breaker or GFCI. Temperature Display: During normal use this display shows the actual water temperature. When the Set Temp indicator is lit, the display shows the set temperature.
ADJUSTING THE FILTER CYCLE Each cycle can run for 60, 120, or 180 minutes. To change the length of the cycle, press the light and up buttons at the same time. The length of the cycle will appear in the temperature display. Use the up and down buttons to select the desired cycle length. The spa filter cycle runs automatically to clean the water in the spa. However, the number of times that the filter cycle needs to run depends on how often the spa is used.
MAINTENANCE The hydrotherapy spa is designed to provide you with years of enjoyment. Please follow the guidelines below to properly maintain your hydrotherapy spa. MAINTAINING THE SPA COVER The spa cover should be cleaned monthly. To clean the spa cover, use water and a non-abrasive cleaner on the entire cover. Rinse the cover with a garden hose to remove any cleaner residue. Dry the cover entirely. You should also use a non-silicone based vinyl conditioner on the cover after you clean it.
WATER CHEMISTRY ATTACHING AND REMOVING THE ACCESS COVER The hydrotherapy spa comes with a starter chemical pack for maintaining the water in the spa. (See TESTING AND TREATING THE WATER on page 12.) Additional chemicals can be purchased at a pool and spa supply store. To remove the access cover, remove the four access cover screws from the access cover. Slide the access cover down and pull the bottom of the access cover away from the Spa Unit.
To drain the hydrotherapy spa, follow these steps: 1. Set the temperature control on the console to the lowest setting. 2. Shut off the circuit breaker or GFCI. 3. Remove the access cover from the back of the spa unit. 4. Remove the drainage hose from the clip and attach a garden hose to the valve on the drainage hose. Cut-off Valve Cut-off Valve Knob Cap Valve If you are planning to work on the pump/motor, you will also need to drain the pump (see this page).
CHECKING AND CLEANING THE FILTER The filter should be checked periodically for build-up of dirt and oil. To check or clean the filter, it is necessary to remove the basket and the two filter cartridges from the filter housing. 4. 5. Removing and Cleaning the Basket: 1. Turn off the power. 2. Pull the weir door towards you until it is fully open. 3. Reach into the basket with four fingers and pull the basket towards you until it snaps free. 4.
TROUBLE-SHOOTING Most problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time. 1. SYMPTOM: THE SPA WILL NOT OPERATE 6. SYMPTOM: THE WATER DOES NOT HEAT a. Check to see if the GFCI breaker is tripped, or was not turned on. Reset the GFCI breaker. a.
9. SYMPTOM: THE WATER LEVEL DROPS 10. SYMPTOM: THE SPA CONTINUES TO RUN AFTER IT HAS BEEN SHUT OFF a. Some water loss due to evaporation is normal. If rapid water loss occurs, or if you notice wetness on the floor around the hydrotherapy spa, then the spa shell may have a leak. Contact your local spa and pool service provider for repairs. a. To turn the spa jets on high, press the Pump button once. To turn the spa jets on low, press the control twice.
PART LISTÑModel No. 831.210051 Key No. Qty. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 8 4 6 4 4 1 1 4 1 2 1 1 1 1 1 1 1 1 4 2 2 2 2 2 6 Description R0698A Key No. Qty.
EXPLODED DRAWINGÑModel No. 831.
Model No. 831.210051 QUESTIONS? As a manufacturer, we are committed to providing complete customer satisfaction. If you have questions, or find that there are missing or damaged parts, we will guarantee complete satisfaction through direct assistance from our factory. TO AVOID UNNECESSARY DELAYS, PLEASE CALL DIRECT TO OUR TOLL-FREE CUSTOMER HOT LINE. The trained technicians on our customer hot line will provide immediate assistance, free of charge to you.
